TM 5-5420-234-14&P
This task covers:
a. Disassembly
c. Assembly
b. Cleaning/Inspection
d. Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Main cylinder harness removed from junction
Tool Kit, General Mechanic's:
Automotive (SC 5180-90-N26)
Main frame valve (load) harness removed from
Materials/Parts
Main frame valve (unload) harness removed from
Adhesive-Sealant, Silicone, RTV
Main junction box harness (24 pin) removed from
Main junction box harness (front) removed from
Equipment Condition
Main junction box harness (rear) removed from
Free flow valve harness removed from
Oil temperature sensor and harness removed from
Hand-held spotlight harness removed from
Right hand linking harness removed from
Hook arm valve (load) harness removed from
Winch (in) harness removed from junction
Hook arm valve (unload) harness removed from
Winch (out) harness removed from junction
Left hand linking harness removed from junction
Hook arm down proximity switch wiring removed
a. Disassembly.
NOTE
Tag and mark all wires prior to removal to ensure proper installation.
(1) Remove jumper wire (1) from terminal no. 2 (2) and terminal no. 7 (3).
(2) Remove jumper wire (4) from terminal no. 14 (5) and terminal no. 16 (6).
(3) Remove jumper wire (7) from terminal no. 18 (8) and terminal no. 20 (9).
(4) Remove jumper wire (10) from terminal no. 20 (9) and terminal no. 22 (11).
(5) Remove jumper wire (12) from terminal no. 22 (11) and terminal no. 24 (13).
Change 1