TM 5-5420-234-14&P
This task covers:
a.
Removal
b. Installation
c.
Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Gasket (Item 109, Appendix K)
Tool Kit, General Mechanic's: Automotive
Locknut (4) (Item 110, Appendix K)
(SC 5180-90-N26)
Equipment Condition
Materials/Parts
Batteries disconnected (TM 9-2320-279-20)
Cable Ties (Item 8, Appendix E)
Tag, Identification (as required) (Item 23, Appendix E)
a. Removal.
NOTE
Cut cable ties as required.
(1) Open hydraulic cabinet cover (1).
(2) Loosen four screws (2) and open junction box cover (3).
NOTE
Tag and mark wires prior to removal to ensure proper installation.
(3) Remove white wire no. 33 (4) from terminal no. 33 (5) and black wire no. 34 (6) from terminal no. 34
(7).
(4) Remove four locknuts (8), washers (9) and screws (10) from junction box (11) and gently pull junction
box forward to access nut (12). Discard locknuts.
NOTE
Note position of rubber grommet prior to removal.
(5) Remove nut (12), plastic insert (13) and rubber grommet (14) from junction box (11).
(6) Remove winch (out) harness (15) from junction box (11).
(7) Loosen screw (16) and remove connector (17) and gasket (18) from directional control valve (19).
Discard gasket.
(8) Remove nut (12), plastic insert (13), and rubber grommet (14) from winch (out) harness (15).
Change 1
