TM 5-5420-234-14&P
This task covers:
a.
Removal
b. Installation
c.
Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Tag, Identification (as required) (Item 23, Appendix E)
Tool Kit, General Mechanic's: Automotive
Gasket (Item 109, Appendix K)
(SC 5180-90-N26)
Equipment Condition
Materials/Parts
Batteries disconnected (TM 9-2320-279-20)
Cable Ties (Item 8, Appendix E)
a. Removal.
NOTE
Cut cable ties as required.
(1) Open hydraulic cabinet cover (1).
(2) Loosen four screws (2) and open junction box cover (3).
NOTE
Tag and mark wires prior to removal.
(3) Remove white wire no. 35 (4) from terminal no. 35 (5) and black wire no. 36 (6) from terminal no. 36
(7).
NOTE
Note position of rubber grommet prior to removal.
(4) Remove nut (8), plastic insert (9) and rubber grommet (10) from junction box (11).
(5) Remove winch (in) harness (12) from junction box (11).
(6) Loosen screw (13) and remove connector (14) and gasket (15) from directional control valve (16).
Discard gasket.
(7) Remove nut (8), plastic insert (9), and rubber grommet (10) from winch (in) harness (12).
b. Installation.
NOTE
Ensure rubber grommet is installed as noted during removal.
(1) Install rubber grommet (10), plastic insert (9), and nut (8) on winch (in) harness (12).
Change 1
