TM 5-5420-234-14&P
4-39. BAP WINCH ASSEMBLY REPLACEMENT (continued).
(9) Remove four bolts (30), lockwashers (31), and nuts (32) from base of winch assembly (29). Discard
lockwashers. Remove winch assembly (29) from winch frame (15).
(10) Remove pipe plug (10) from end cover (11), and drain remaining oil into a suitable container. Install
pipe plug (10) in end cover (11).
32
31
29
10
30
11
15
b. Cleaning and Inspection.
WARNING
Drycleaning solvent is TOXIC and flammable. Wear protective goggles and
gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes;
and DO NOT breathe vapors. Keep away from heat or flame. Never smoke when
using drycleaning solvent; the flashpoint for Type II is 140 degrees F (60 degrees
C), and for Type III it is 200 degrees F (93 degrees C). Failure to follow this warning
may result in death or injury to personnel.
Do not use drycleaning solvent on winch cable. Solvent will soak into strands of
cable and result in rust forming inside cable, which will cause cable to deteriorate
and weaken much faster than usual. This could result in cable breaking under
normal loads and could cause death or injury to personnel.
(1) Clean all parts except winch cable using drycleaning solvent and rag.
(2) Inspect all hardware and parts for wear or damage that would make them unserviceable. Replace any
damaged, unserviceable, or missing hardware and parts.
4-486
