TM 5-5420-234-14&P
4-39. BAP WINCH ASSEMBLY REPLACEMENT (continued).
NOTE
If there is no tension of cable against roller assemblies, install spring on higher
hole until tension exists.
(6) Install one end of each of two cable guide springs (12) on upper cable guide shaft (16). Install other end
of each of two springs (12) on two bolts (13) that are on brackets (14).
(7) Remove filler plug (34) from end cover (11), and fill winch with oil (Appendix G). Install filler plug
(34) in end cover (11).
34
8
4
3
5
6
11
7
9
6
5
4
3
(8) Install tube (8) on elbow (9). Install two elbows (4) and new O-rings (6) on winch motor (7), and tighten
two captive nuts (5). Install two hydraulic tubes (3) on elbows (4).
d. Follow-on Maintenance:
Install winch cable (para 4-38).
END OF TASK
4-489
