TM 5-5420-234-14&P
This task covers:
a. Removal
c. Installation
b. Cleaning and Inspection
d. Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Cotter Pin (4) (Item 18, Appendix K)
Pan, Drain, 4-Gallon (MIL-P-45819)
Lockwasher (8) (Item 33, Appendix K)
Lifting Device, Minimum Capacity 350 lb (158.9 kg)
Lockwasher (4) (Item 35, Appendix K)
Tool Kit, General Mechanic's: Automotive
O-ring (2) (Item 83, Appendix K)
(SC 5180-90-N26)
Personnel Required
Materials/Parts
Two
Cap and Plug Set (Item 9, Appendix E)
Gloves, Protective (Item 15, Appendix E)
Equipment Condition
Goggles, Safety (Item 16, Appendix E)
Load removed from the BAP (para 2-12)
Lubricating Oil (Item 20, Appendix E)
BAP unloaded from the CBT (para 2-10)
Rag (Item 21, Appendix E)
a. Removal.
WARNING
If winch cable has to be cut to remove winch assembly, wrap cut end of cable in tape
and secure loose end of cable to prevent it from swinging free during winch assembly
removal. Failure to follow this warning could result in injury to personnel.
CAUTION
To prevent contamination of hydraulic system, cap and/or plug hydraulic lines and
ports after disconnecting lines.
NOTE
If winch is inoperative, it can be removed only by cutting the cable.
Use a suitable container to catch fluid draining from hoses and fittings. Wipe
up any spillage with a rag.
(1) If winch can be operated to play out winch cable (1), remove winch cable (1) (para 4-38). If winch
cannot be operated to play out winch cable, cut cable (1) close to hook holder (2).
