TM 9-2320-279-20-2
Winches, Cranes, and Power Takeoff (PTO) Maintenance Instructions (Cont)
17-28.1 HYDRAULIC PUMP REMOVAL/INSTALLATION (M984E1) (CONT).
(3)
Install two washers (8), bracket
washers (8), and nuts (10) on pump
(1).
NOTE
Trucks with guard, perform steps (4) and
(4.1) through (11). Trucks without guard,
perform steps (4) and (5) through (11).
(4)
Install two screws (11), spacers (12),
lockwashers (13), and washers (14) on
bracket (9).
NOTE
Trucks with guard, ensure guard is fully seated under flat washers.
(4.1) Install guard (4.1) under two flat washers (4.2) and tighten two screws (4.3) and
lockwashers (4.4).
(5)
Install two preformed packings (15) in hoses (16).
(6)
Install two hoses (16) on pump (17) with four clamp halves (18), screws (19), and
lockwashers (20).
(7)
Install preformed packing (21) in hose (22).
(6)
Install hose (22) on pump (17) with two clamp halves (23), four screws (24), and
lockwashers (25).
17-140
Change 2
