(7)
(8)
(9)
(10)
Winches, Cranes, and Power Takeoff
Remove two elbows (12) from PTO (9).
Remove switch (13) from tee (14).
Remove tee (14), coupling (15), and
nipple (16) from PTO (9).
Remove breather (17) and adapter (18).
TM 9-2320-279-20-2
(PTO) Maintenance Instructions (Cont)
b. Installation.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
(1) Apply pipe thread sealing compound and
install breather (1) and adapter (2) in
PTO (3).
(2) Apply pipe thread sealing compound and install nipple (4), coupling (5), and tee (6) in PTO (3).
(3) Apply pipe thread sealing compound and install switch (7) in tee (6).
(4) Apply pipe thread sealing compound and install two elbows (8).
NOTE
Uncover access hole before doing step (5).
(5) Install gasket (9) on transmission housing (10).
(6) Install PTO (3) to transmission housing (10)
with five nuts (11) and washers (12).
(7) Install screw (13).
(8) Tighten nuts (11) and screw (13) to 30 to 35
lb-ft (41 to 47.5 N·m).
17-143
