TM 9-2320-279-20-2
Winches, Cranes, and Power Takeoff (PTO) Maintenance Instructions (Cont)
17-28.2. POWER TAKE OFF REMOVAL/INSTALLATION (M984E1) (CONT).
(9)
(10)
(11)
(12)
(13)
(14)
(15)
17-144
Remove four screws (14) and cover plate (15) from PTO (2).
NOTE
Gear should move when pressure is applied. If gear moves, backlash is OK. If gear
does not move, correct backlash.
Check backlash on gear (16) by applying pressure to gear. If gear moves, continue with step (15).
If gear does not move, continue with step (11).
Remove five nuts (11) and washers (12).
Remove screw (13).
Install a second gasket (17) on transmission housing (10).
Repeat steps (6) through (8) then go to step (10) and recheck backlash.
Install cover plate (15) on PTO (2) with four screws (14).