TM 5-5420-234-14&P
4-90. WINCH (OUT) HARNESS REPLACEMENT (MODEL A ONLY) (continued).
b. Installation.
11
7
5
6
1
4
2
14
8
3
9
19
18
10
17
13
12
15
16
OTHER WIRE HARNESSES
REMOVED FOR CLARITY
NOTE
Ensure rubber grommet is installed in same position as noted during removal.
(1) Install rubber grommet (14), plastic insert (13), and nut (12) on winch (out) harness (15).
NOTE
Install cable ties as required.
(2) Install new gasket (18) and connector (17) to directional control valve (19) and tighten screw (16).
(3) Position winch (out) harness (15) in junction box (11).
(4) Install rubber grommet (14), plastic insert (13), and nut (12) on junction box (11).
(5) Install junction box (11) on vehicle (19) with four screws (10), washers (9) and new locknuts (8).
(6) Install black wire no. 34 (6) on terminal no. 34 (7) and white wire no. 33 (4) on terminal no. 33 (5).
(7) Close junction box cover (3) and tighten four screws (2).
(8) Close hydraulic cabinet cover (1).
c. Follow-on Maintenance:
Connect batteries (TM 9-2320-279-20).
END OF TASK
4-653
4-653
Change 1
