TM 5-5420-234-14&P
4-53. LHS ANGLED ROLLER REPLACEMENT (continued).
(4) Remove lube fitting (4), two screws (5), lockwashers (6), data plate bracket (7), lockplate (8), four screws
(9), lockwashers (10) and endplate (11). Discard lockwashers.
4
7
8
11
5
6
9
10
(5) Using a soft faced hammer, remove roller (12) from roller assembly (13).
b. Installation.
12
(1) Position roller (12) in roller assembly (13).
and screws (9).
13
(3) Install lockplate (8), bracket (7), two new
lockwashers (6) and screws (5).
(4) Install lube fitting (4) in roller assembly (13).
(5) Install new lockwasher (2), new locknut (3) and
grease fitting (1). Tighten locknut.
(6) Bend tab of lockwasher (2) into slot of locknut
(3).
c. Follow-on Maintenance:
Lubricate rear rollers (Appendix G).
Remove wheel chocks (TM 9-2320-279-10).
END OF TASK
