TM 5-5420-234-14&P
NOTE
During all Transporter operations, the operator will drive and be responsible for the
operation of the LHS cab control box. The assistant acts as a ground guide and will
be responsible for directing the operator using hand signals, operating the remote
control and winch, and assisting the operator as needed.
a. Position Transporter with its rear about 16 feet (4.9 m) in front of where the rear of the BAP is to be set on
the ground.
2
1
b. Apply service brake or parking brake and place transmission in neutral.
c. Secure winch frame to the BAP. Make sure two winch
frame locking levers (1) are in the up position. If locking
levers (1) are not up:
(1)
Remove lockpin (2) from each locking lever (1).
(2)
Swing each locking lever (1) to the up position.
(3)
Insert lockpin (2) into each locking lever (1).
d. Connect two hydraulic hoses (3) to the stowed location connections (4).
e.
Make sure BAP air hose (5) located on road side of the BAP is in the stowed position connected to elbow (6).
5
4
3
6
