TM 9-2320-279-34-2
Winch Maintenance Instructions (Cont)
I 16-4. SELF-RECOVERY WINCH HYDRAULIC MOTOR REPAIR (CONT). I
(7)
(8)
(9)
(10)
(11)
Keep
Coat seal (5) with grease and install
seal in bearing housing (3).
Coat shaft face seal (6) with grease
and install in wear plate (7).
Install wear plate (7) on bearing
housing (3).
Coat two seals (8 and 9) with grease
and install in wear plate (7).
Install drive (10) in bearing
housing (3).
NOTE
rollers in outer ring of geroler if
rollers are loose.
(12) Aline case drain hole in geroler (11)
with case drain hole in wear
plate (7).
(13) Install geroler (11) on wear
plate (7).
NOTE
Do steps (14) through (18) to time hydraulic
motor for maximum power.
(14)
(15)
(16)
(17)
(18)
Find largest open pocket in geroler (11)
Mark location on outside of geroler.
Install valve drive (12) in geroler (11).
Coat seals (13 and 14) with grease and
install in valve plate (15).
Install valve plate (15) on geroler(11).
Aline timing mark on valve (16) with
matchmark on outside of geroler (11)
and install valve on valve plate (15).
(19) Install two springs (17) and two pins (18)
in holes of valve housing (19).
(20) Coat two seals (20 and 21) with grease
and install seals in valve housing (19).
16-12
