TM 9-2320-279-34-2
Winch Maintenance Instructions (Cont)
(21) Coat inner and outer face seals (22 and 23) with
grease and install seals on balance ring (24).
(22) Aline pin grooves in balance ring (24) with two
pins (18) in valve housing (19).
(23) Install balance ring (24) in valve housing (19).
NOTE
Insert knife through hole in valve housing to keep
balance ring in place during installation.
(24) Apply pressure to side of balance ring (24) to
hold in place.
(25) Install valve housing (19) on valve plate (15).
(26) Install four screws (25) and tighten
alternately to 35 to 40 lb-ft (47 to
54 N·m).
(27) Install two steel balls (26),
springs (27), preformed packings (28),
and check plugs (29) in valve
housing (19).
(28) Coat seal (30) with grease and install
seal on plug (31).
(29) Install plug (31) in valve housing (19).
Tighten to 4 lb-ft (5 N·m).
d. Follow-on Maintenance. None.
END OF TASK
16-13