TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-16. REAR COVER AND FIRST CLUTCH ASSEMBLY REMOVAL/REPAIR/
INSTALLATION (CONT).
(17)
Remove inner seal ring (20) and
outer seal ring (21) from first clutch
piston (16).
(18)
(19)
Position rear cover (1) flange side down. Use wooden blocks for support.
Remove governor support pin (22) from rear cover (1).
C.
Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
(1)
(2)
Clean all metal parts with drycleaning solvent and inspect for damage. Replace damaged parts.
Inspect and replace piston release springs if any five springs do not meet the following
load-height requirements:
(a)
Length without load must be at least: 1.31 in. (33.3 mm).
(b)
Length under load must be at least: 0.90 in. (22.9 mm) with load of 26.05 to 27.85 lb (115.9
to 123.9 N).
7-110
Change 3
