TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-16. REAR COVER AND FIRST CLUTCH ASSEMBLY REMOVAL/REPAlR/lNSTALLATlON.
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning/Inspection
f. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Special Tools
Clutch spring compressor J24204
Output shaft bushing installer J24203
Supplies
Oil, lubricating, Item 46, Appendix C
Solvent, dry cleaning, Item 57, Appendix C
Compound, retaining, Item 24, Appendix C
Compound, sealing, pipe thread, Item 29,
Appendix C
Grease, general purpose, lithium base,
Item 36, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
Reference
None
Equipment Condition
TM or Para
Condition Description
Para 7-14
Output yoke, dust shield,
and oil seal removed.
Para 7-23
Governor removed.
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
General Support
a. Removal.
(1) Position transmission (1) so output
shaft (2) is pointing up.
(2) Install yoke (3) and nut (4).
(3) Remove three screws (5) and
lockwashers (6).
(4) Remove 21 screws (7) and
lockwashers (8).
7-106