TM 9-2320-279-34-1
(14)
(15)
(16)
(17)
Transmission Maintenance Instructions (Cont)
Install 30 piston release springs (13) in
first clutch piston (3).
Install piston spring retainer (14) on
piston release springs (13).
Using clutch spring compressor, push
down on piston spring retainer (14) and
piston release springs (13) until
retaining ring groove in rear cover (8)
is cleared.
Install retaining ring (15). Remove
clutch spring compressor.
NOTE
The orifice plug must clear the chamfer at the
front of the plug bore in the output shaft.
(18)
(19)
(20)
(21)
(22)
Install small orifice plug (16) in output
shaft (17).
NOTE
Bushing must be 0.145 to 0.165 in. (3.68 to 4.19 mm) from front end of output
shaft.
Coat output shaft bushing (18) with
retaining compound.
Install output shaft bushing (18) in
output shaft (17) using output shaft
bushing installer.
Install speedometer drive gear (19),
spacer (20), and bearing (21) on output
shaft (17).
Install output shaft (17) in rear
cover (8).
Change 3
7-113
