TM 9-2320-279-34-1
Transmission Maintenance instructions (Cont)
7-16. REAR COVER AND FIRST CLUTCH ASSEMBLY REMOVAL/REPAIR/
INSTALLATION (CONT).
(23)
Install retaining ring (22), yoke (23),
and nut (24).
WARNING
Adhesives, solvents, and sealing compounds can burn
easily, can give off harmful vapors, and are harmful
to skin and clothing. To avoid injury or death, keep
away from open fire and use in well-ventilated area.
If adhesive, solvent, or sealing compound gets on skin
or clothing, wash immediately with soap and water.
(24)
Lightly coat threads of plug (25) and plug
(25.1) with pipe thread sealing compound
and install in rear cover (8).
(25)
Install bushing (25.2) and plug (26) in rear
cover (8).
(26)
Torque plug (25), plug (25.11, and plug (26)
to 4 to 5 lb-ft (5 to 7 Nm).
e.
Installation.
(1)
Soak six friction plates (1) in clean lubricating
oil for at least 2 minutes.
NOTE
If thick steel clutch plates are included in clutch plate
stack, install thick steel clutch plates on top of stack for
proper pressure distribution.
(2)
Install 10 clutch plates (1 and 2) in
transmission housing (3), starting with steel
plate (2) and alternating with friction plate (1).
(3)
Install rear planetary ring gear (4) in
transmission housing (3).
(4)
Install three clutch plates (1 and 2) in
transmission housing (3), starting with steel
plate (2) and alternating with friction plate (1).
7-114
Change 3
