TM 5-5420-234-14&P
Section III. TRANSPORTER MAINTENANCE PROCEDURES
Sections II and III contain instructions for replacement and repair of Common Bridge Transporter (CBT) components
authorized at the Direct Support level by the Maintenance Allocation Chart. In some cases, components must be removed
before performing the task. In these cases, references are provided to the applicable chapters or paragraphs. This section
contains maintenance procedures for the Transporter. Section II contains a maintenance procedure for the Bridge Adapter
Pallet (BAP).
This task covers:
a.
Removal
b. Installation
c.
Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic's:
LHS fully extended (para 2-10)
Automotive (SC 5180-90-N26)
Materials/Parts
Locknut (16) (Item 54, Appendix K)
a. Removal.
(1) Remove eight locknuts (1), screws (2) and nose support bracket (3) from crossmembers (4). Discard
locknuts.
(2) Remove eight locknuts (5), screws (6), two plates (7), and plates (8) from left and right gusset (9 and 10).
Discard locknuts.
NOTE
If removal of front intermediate crossmember is required, refer to TM 9-2320-279-
34-2 HEMTT manual.
b. Installation.
(1) Install two plates (7) and plates (8) on gussets (9) and (10) with eight screws (6) and new locknuts (5).
NOTE
Nose support bracket must be installed so ears on bracket are positioned toward front
of vehicle.
(2) Install nose support bracket (3) on crossemember (4) with eight screws (2) and new locknuts (1).
