TM 5-5420-234-14&P
This Task Covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Personnel Required
Tools and Special Tools
Two
Tool Kit, General Mechanic's:
Automotive (SC 5180-90-N26)
Equipment Conditions
Compression frame removed (para 5-14)
Materials/Parts
Wheel chock stowage box removed
Locknut (14) (Item 54, Appendix K)
(for left rear bracket only) (TM 9-2320-279-20-2)
a. Removal.
NOTE
Left and right compression frame mounting brackets are removed the same way.
With the help of an assistant, remove seven locknuts (1), four 4.00 in. (102 mm) screws (2), three 3.75 in. (95 mm)
screws (3), seven washers (4), spacers (5), and rear compression frame mounting bracket (6) from frame (7).
Discard locknuts.
b. Installation.
NOTE
Left and right compression frame mounting brackets are installed the same way.
(1)
With the help of an assistant, install rear compression frame mounting bracket (6) on frame (7) with four 4.00
in. (102 mm) screws (2), three 3.75 in. (95 mm) screws (3), seven washers (4), spacers (5), and new
locknuts (1).
(2)
Tighten locknuts to 210 lb-ft (285 Nm).
c. Follow-on Maintenance:
Install wheel chock stowage box (for left rear bracket only) (TM 9-2320-279-20-2).
Install compression frame (para 5-14).
END OF TASK
Change 2
