TM 5-5420-234-14&P
This task covers:
a. Removal
c. Installation
b. Cleaning and Inspection
d. Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Lockwasher (2) (Item 31, Appendix K)
Pan, Drain, 4-Gallon (MIL-P-45819)
Lockwasher (2) (Item 35, Appendix K)
Tool Kit, General Mechanic's: Automotive
O-ring (2) (Item 48, Appendix K)
(SC 5180-90-N26)
O-ring (Item 81, Appendix K)
O-ring (2) (Item 82, Appendix K)
Materials/Parts
O-ring (2) (Item 83, Appendix K)
Drycleaning Solvent (Item 13, Appendix E)
Preformed Packing (Item 71, Appendix K)
Grease (Item 17, Appendix E)
Rag (Item 21, Appendix E)
Equipment Condition
Backup Ring (Item 70, Appendix K)
Load removed from the BAP (para 2-12)
BAP removed from the CBT (para 2-10)
NOTE
Use a drain pan to catch fluid draining from hoses and
fittings. Wipe up any spillage with a rag.
a. Removal.
CAUTION
Do not remove tube nuts and flared tube sleeves from
hydraulic tubes unless there is leakage or other damage to
tubes, tube nuts, or flared tube sleeves that make them
unserviceable.
NOTE
Tag all hoses and tubes before disconnecting. Note if each
hose or tube has a male or female connector.
4
2
(1) Remove male quick-disconnect coupling half (1) from dummy female
quick-disconnect coupling half (2).
5
6
(2) Remove female quick-disconnect coupling half (3) from dummy male
1
quick-disconnect coupling half (4).
3
(3) Remove backup ring (5) and preformed packing (6) from female
9
9
quick-disconnect coupling half (3). Discard backup ring and
preformed packing.
7
(4) Remove male quick-disconnect coupling half (1) from hose (7).
8
(5) Remove female quick-disconnect coupling half (3) from hose (8).
Remove two O-rings (9) from male quick-disconnect coupling half (1)
and female quick-disconnect coupling half (3). Discard O-rings.
