TM 9-2320-279-34-2
Winch Maintenance Instructions (Cont)
(2.1) Remove four screws (6.1).
(2.2) Carefully pry flange (6.2) off motor (5).
(2.3) Remove preformed packing (6.3) and
seal ring (6.4) from flange (6.2).
CAUTION
Motor is factory set. Do not remove setscrews or
jamnuts.
NOTE
Lockwashers are only used on Model A.
(3)
Remove eight screws (7), lockwashers (8),
plate (9), gasket (10), and lens (11) from
motor (5).
NOTE
Do steps (4) through (7) for Model A. Do steps
(7.1) through (7.3) for Model B.
(4)
Remove two plugs (12) and preformed
packings (13).
(5)
Remove four screws (14), lockwashers (15),
plate (16), and two preformed packings (17).
NOTE
Use care when removing subassembly to
prevent from coming apart.
(6)
Remove subassembly (18) from plate (9).
(7)
Remove preformed packing (19) from
subassembly (18).
Change 2
16-54.1
