TM 9-2320-279-34-2
Winch Maintenance Instructions (Cont)
(15) Remove valve plate (26).
(16) Remove preformed packing (27) from valve
plate (26).
(17) Remove valve drive (28) from geroler (29).
NOTE
Hub and pins in geroler are a
matched set. Be careful hub
and pins do not fall out.
(18) Remove geroler (29),
drive (30), and preformed
packings (31 and 32) from
bearing housing (33).
(19) Turn bearing housing (33)
over in vise.
(20) Remove eight screws (34)
and front retainer (35).
CAUTION
Do not try to remove both
seals at same time or damage
to mounting flange will result.
(21)
(22)
Remove shaft seal (36) from
front retainer (35).
Remove dust seal (37).
(23)
(24)
(25)
Remove preformed packing (38) from bearing
housing (33).
Press shaft and bearings (39) out of bearing
housing (33).
Remove shaft face seal (40) from bearing
housing (33).
16-49
