TM 9-2320-279-34-2
Winch Maintenance Instructions (Cont)
(13)
(14)
(15)
(16)
(17)
Pour small amount of
lubricating oil inside bearing
housing (1).
Coat preformed packing (9)
with grease and install in
groove of bearing housing (1).
Install drive (10) in shaft and
bearing assembly (3).
Coat two preformed
packings (11 ) with grease and
install in geroler (12).
Install geroler (12) on bearing
housing (1).
NOTE
l Aline case drain holes.
l Do steps (18) through (22) to
time hydraulic motor for
maximum power.
(18)
(19)
(20)
(21)
(22)
Find largest open pocket in
geroler (12). Mark location on
outside of geroler.
Install valve drive (13) in
geroler (12).
Coat preformed packing (14)
with grease and install in
valve plate (15).
Install valve plate (15) on
geroler (12).
Aline timing mark on
valve (16) with matchmark on
outside of geroler (12) and
install valve on valve
plate (15).
(23) Install two springs (17) inside valve housing (18).
(24) Coat preformed packings (19 and 20) with grease and install in valve housing (18).
(25) Coat inner face seal (21) and outer face seal (22) with grease and install on balance ring (23).
16-51
