TM 9-2320-279-20-2
Cab and Body Maintenance Instructions (Cont)
d. Installation.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death keep
away from open fire and use in a
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
l
l
l
l
l
l
l
NOTE
Left and right lower boxes are installed
the same way.
Before applying protective coating clean
all old adhesive from lower boxes and
mating surface of wrecker body.
Coat bottom of lower box with
protective
coating and allow to dry.
Coat rear side of left lower box with
protective coating and allow to dry.
(1)
(2)
(3)
Install lower box (1) on wrecker body floor (2).
NOTE
Do step (2) only on left side.
l Right lower box has six screws.
Install rear bracket (3) on lower box (1) with two screws (4) and locknuts (5).
Soldier A installs 10 screws (6) and washers (7) in lower box (1) while Soldier B installs
washers (7) and locknuts (8).
NOTE
Before applying protective coating clean
all old sealant and protective coating
from upper box and mating surface of
lower boxes and wrecker body.
Coat rear side of left upper box with
protective coating and allow to dry.
App1y adhesive sealant around screw
holes on top of lower box.
(4) Attach suitable lifting device and install
upper box (9) on lower box (1).
16-233
