Cab and Body Maintenance
NOTE
l All latches are installed the same way.
Bend tabs on tab washer against sides of
nut.
(5) Install handle (8) and shaft (9) in
door (2) with stop washer (10),
plate (11), spring washer (12), tab
washer (13), nut (14), pawl (15), and
screw (16).
NOTE
Do not install rear bracket in upper and
lower box.
(6) Install bracket (17) in lower box (18)
with two screws (19) and nuts (20).
NOTE
When installing locknut on rod, tighten
locknut until the distance between collar
on rod and locknut measures
approximately 7.25 in. (185 mm).
All lower doors are installed the same
way.
Upper doors are welded. Refer to
TM 9-237 for welding instructions.
(7) Install spring (21) on rod (22) through
bracket (17) with locknut (23).
(8) Install rod (22) on door (2) with
washer (24) and cotter pin (25).
Instructions (Cont)
TM 9-2320-279-20-2
16-232
