TM 5-5420-234-14&P
This task covers:
a. Removal
c. Installation
e. Follow-on Maintenance
b. Cleaning and Inspection
d. Adjustment
INITIAL SETUP
Tools and Special Tools
Lockwasher (5) (Item 32, Appendix K)
Tool Kit, General Mechanic's Automotive
Self-Locking Nut (Item 38, Appendix K)
(SC 5180-90-N26)
Self-Locking Nut (11) (Item 39, Appendix K)
Spring Pin (Item 7, Appendix K)
Materials/Parts
Drycleaning Solvent (Item 13, Appendix E)
Equipment Condition
Rag (Item 21, Appendix E)
Load removed from the BAP (para 2-12)
Cotter Pin (Item 22, Appendix K)
BAP removed from the CBT (para 2-10)
a. Removal.
WARNING
Support BAP rear guide in place when
removing pivot pin. Without support,
BAP rear guide could fall and cause
injury to personnel or damage to
equipment.
NOTE
Rear guide latch handle must be
in locked position and rear guide
in full open position before
performing task.
2
This task can be used for either
curb-side or road-side rear
9
3
guide. Road side is shown.
(1) Remove 11 screws (1) and self-locking nuts
10
(2) from rear guide pad (3) and rear guide
(4). Discard self-locking nuts.
4
(2) Remove rear guide pad (3) from rear guide
7
(4).
6
and nuts (7) from lock bracket (8) and rear
guide (4). Discard lockwashers.
1
(4) Remove screw (9) and lockwasher (10) from
8
5
rear guide (4) and lock bracket (8). Remove
rear guide (4) from lock bracket (8). Discard
lockwasher.
