TM 9-2320-279-34-2
Cab and Body Maintenance Instructions (Cont)
15-7. H1 AND H2 FUEL TRANSFER HOSE REEL REPAIR (M978) (CONT).
(7)
(8)
Position front disk (10) on hub assembly (4) and install ring gear (II) and six nuts (12).
Install washer (13), two screws (14), bearing holder (15), ball bearing (16), pillow block (17), and
nuts (18).
NOTE
The packing style joint assembly requires occasional tightening for proper sealing.
The two screws should be tightened alternately and evenly until the lockwashers
are flattened and/or there is no evidence of leakage. Care should be taken to
alternately tighten each screw in 1/4 turn increments. Do not completely tighten
one screw and then the other.
(9)
Install washer (19), follower (20), packings (21), packing gland (22), two screws (23), and
lockwashers (24) on hub assembly (4) and front disk (10).
(10)
(11)
Install reel (25) in front frame (26) and back frame (27).
(12)
Install two screws (28) and spacers (29) through front frame (26) into packing gland (22)
Install two screws (30) through pillow block (17) and rear frame (27) and install two nuts (31).
15-38
Change 2
