TM 9-2320-279-34-2
Cab and Body Maintenance Instructions (Cont)
b. Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
(1)
Clean all metal parts of hose reel with drycleaning solvent.
(2)
Inspect parts for damage.
(3)
Replace all damaged parts.
C.
Assembly.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
NOTE
H1 and H2 fuel transfer hose reels are assembled the same way. H2 fuel transfer hose
reel is shown.
Ensure nipple is 2.5 in. (63.5 mm) long. If length is not correct, replace with standard
nipple (P/N MS 51593-171).
(1)
Apply silicone adhesive-sealant to gasket (1) and install on flanged riser (2).
(2)
Apply pipe thread sealing compound and install nipple (3) in flanged riser (2).
(3)
Install flanged riser (2) on hub assembly (4) with four screws (5).
(4)
Insert six screws (6) through inner holes of back disk (7).
(5)
Position spacer pipes (8) over each screw (6) and place drum (9) over screws and spacer pipes.
(6)
Install flanged riser (2) and hub assembly (4) in center hole of back disk (7) so flanged riser fits in
gap of drum (9).
Change 2
15-37
