TM 9-2320-279-34-1
7-152
Change 5
Transmission Maintenance Instructions (Cont)
7-20. CONTROL VALVE BODY REMOVAL/REPAIR/INSTALLATION (CONT).
(44)
Insert six screws (97) through oil
transfer plate (89), separator plate (96),
and control valve body (1) to aline
screw holes.
(45)
Place modulator valve body (83) on oil
transfer plate (89) and install three
screws (98).
(46)
Tighten screws (98) to 8 to
12 lb-ft (11 to 16 NSm).
(47)
Remove six screws (97).
e.
Installation.
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
CAUTION
Care must be exercised when grinding the
locator boss. The transmission must remain
clean and free of contamination. Failure to
comply may result in damage to equipment.
NOTE
·
If replacing modulator valve body
with the manufacturer logo ,
transmission housings manufactured
prior to 1986 may need to be altered.
·
Identify transmission housing
casting date located on the right or
left hand side of the transmission
housing.
·
If date in casting indicates casting
prior to 1986, go to step (1).
·
If date in casting indicates casting
after 1986, go to step (1.3).
·
Transmission housing described
above are altered by removing
material from the locator boss.
I
M
