TM 9-2320-279-20-3
Body Accessory Maintenance Instructions (Cont)
(4)
Connect air lines (3 and 4).
(5)
Install panel (2).
(6)
Install and tighten eight screws (1).
c.
Follow-on Maintenance.
(1)
Connect batteries (para 7-91).
(2)
Start engine and build up air pressure (TM 9-2320-279-10).
(3)
Check for air leaks.
(4)
Check operation of windshield washer control valve (TM 9-2320-279-10).
(5)
Shut off engine (TM 9-2320-279-10).
END OF TASK
18-9. LEFT AND RIGHT WINDSHIELD WIPER CONTROL VALVE REMOVAU
INSTALLATION.
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
I
Models
All
References
None
Test Equipment
None
Special Tools
None
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-10 Shut off engine.
Para 7-91
Batteries disconnected.
TM 9-2320-279-10 Air system drained.
Supplies
Compound, sealing, pipe thread, Item 18,
Appendix C
Tags, identification, Item 48, Appendix C
Personnel Required
MOS 63S. Heavy wheel vehicle mechanic
Special Environmental Conditions
None
General Safety Instructions
None
NOTE
There are two kinds of washer control valves. Model A pulls out to start wipers. Model B
turns clockwise to start wipers. If a Model A control valve must be replaced with a Model B
control valve, the wiper motor for that valve and some fittings must be replaced also. Refer
to TM 9-2320-279-24P for proper identification of parts.
Change 3
18-19
