TM 9-2320-279-20-3
Body Accessory Maintenance Instructions (Cont)
18-8. WINDSHIELD WASHER CONTROL VALVE REMOVAL/INSTALLATION (CONT).
a. Removal.
(1)
Remove eight screws (1) and panel (2).
NOTE
Tag and mark air lines before removal.
(2)
Disconnect air lines (3 and 4) from
windshield washer control valve (5).
(3)
Loosen screw (6) and remove knob (7).
NOTE
There are two models of windshield washer
control valves. Model A has no lockwasher.
Model B uses a lockwasher. Do step (4) for
Model A. Do step (4.1) for Model 8.
(4)
Remove nut (8) and pull windshield
washer control valve (5) out of panel (2).
(4.1) Remove nut (8) and lockwasher (8.1)
and pull windshield washer control
valve (5) out of panel (2).
(5)
Remove elbow (9) from windshield
washer control valve (5).
b. Installation
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid
injury or death, keep away from open fire and
use in well-ventilated area. If adhesive,
solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
NOTE
There are two kinds of washer control valves.
Model A is used with the washer reservoir
mounted behind the passenger seat. Model B
is used with the washer mounted under the
dash. If a Model A control valve must be
replaced with a Model B control valve, the
washer reservoirs must be changed also.
Refer to TM 9-2320-279-24P for proper
identification of parts.
(1)
Coat threads of elbow (9) with pipe thread sealing compound and install elbow in windshield
washer control valve (5).
NOTE
Do step (2) for Model A. Do step (2.1) for Model B.
(2)
Position windshield washer control valve (5) in panel (2). Install and tighten nut (8).
(2.1) Install windshield washer control valve (5) in panel (2) with lockwasher (8.1) and nut (8).
(3)
Install knob (7) on windshield washer control valve (5) and tighten screw (6).
18-18
Change 3
