TM 9-2320-279-20-3
Filter-Separator Maintenance Instructions (Cont)
23-4. FILTER-SEPARATOR REMOVAL/REPAIR/INSTALLATION (M978) (MODEL A)
(CONT).
c.
(13)
Remove two elbows (17) from side of
filter-separator tank (6).
(14)
Remove pipe plug (18) and elbow (19)
from bottom of filter-separator tank (6).
(15)
Remove fitting (20) and bushing (21)
from elbow (19).
Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(1)
Clean all metal parts with drycleaning solvent.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment, goggles, shield, and gloves.
(2)
Dry metal parts with compressed air.
(3)
Inspect each part for damage.
(4)
Replace damaged parts.
23-16
Change 3
