TM 9-2320-279-20-2
Winches, Cranes, and Power Takeoff (PTO) Maintenance Instructions (Cont)
17-23.1. CRANE REMOTE CONTROL CABLE REPAIR (M977, M984E1, M985) (CONT).
a. Disassembly.
(1) Remove cap (1), ring (2), seal (3), fitting (4), and sleeve (5).
(2) Remove pin (6) from connector (7).
(3) Remove wire (8) from pin (6).
Assembly.
(1) Install pin (6) to wire (8).
(2) Install pin (6) in connector (7).
(3) Check each wire in cable for zero ohms between both ends of cable.
(4) Install sleeve (5), fitting (4), seal (3), ring (2), and cap (1).
Follow-on Maintenance.
(1) Check operation of crane remote control (TM 9-2320-279-10).
(2) Stow remote control cable in remote control stowage box (TM 9-2320-279-10).
b.
c.
END OF TASK
17-23.2. CRANE REMOTE CONTROL STATION CABLE AND CONNECTOR
REMOVAL/REPAIR/INSTALLATION (M984E1).
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-on Maintenance
c. Assembly
INITIAL SETUP
Models
M984E1
Test Equipment
None
Special Tools
None
Supplies
Tags, identification, Item 48, Appendix C
Personnel Required
MOS 63S, Heavy wheel vehicle mechanic
References
None
Equipment Condition
TM or Para
Condition Description
Para 7-91
Disconnect batteries.
Special Environmental Conditions
None
General Safety Instructions
None
17-110
