TM 9-2320-279-20-2
Winches, Cranes, and Power Takeoff (PTO) Maintenance Instructions (Cont)
a. Removal.
(1) Remove cap (1) from connector (2).
(2) Remove nut (3) and lockwasher (4) from connector (2).
(3) Remove connector (2) from mounting plate (5).
(4) Remove cap and chain (1) from ring (6).
(5) Remove four rivets (7) and data plate (8) from mounting plate (5).
b. Disassembly.
(1) Remove cap (9), ring (10), grommet (11), adapter (12), from sleeve (13).
(2) Remove sleeve (13) from connector (2) and slide down wiring harness (14).
NOTE
Note position of wires in connector.
(3) Remove 12 wires (15) and two plugs (16) from connector (2).
(4) Remove 12 pins (17) from wires (15).
(5) Remove sleeve (13), adapter (12), grommet (11), ring (10), cap (9), and ring (6) from wiring
harness (14).
c. Assembly.
(1) Install ring (6), cap (9), ring (10), grommet (11), adapter (12), and sleeve (13), on wiring
harness (14).
(2) Install 12 pins (17) on wires (15).
(3) Install 12 wires (15) and two plugs (16) in connector (2).
(4) Install sleeve (13), adapter (12), grommet (11), ring (10), and cap (9) on connector (2).
d. Installation.
(1) Install cap and chain (1) on ring (6).
(2) Install connector (2) in mounting plate (5) with lockwasher (4) and nut (3).
(3) Install cap (1) on connector (2).
(4) Install data plate (8) on mounting plate (5) with four rivets (7).
e. Follow-on Maintenance.
(1) Connect batteries (para 7-91)
(2) Check operation of remote control unit at remote control station (TM 9-2320-279-10).
END OF TASK
17-111
