TM 5-5420-234-14&P
4-68. SUPPLY HARNESS REPLACEMENT (MODEL A ONLY) (continued).
CAUTION
Use caution when removing hardware. Ensure existing HEMTT wires are reinstalled
on proper terminals. Failure to comply may result in damage to equipment.
(2) Remove screw (22) from work light switch (25).
(3) Install wire no. 8 (24) and wire no. 7 (23) on work light switch (25) with screw (22).
(4) Push side panel (21) back into position and install eight screws (20).
(5) Remove screw (17) from high idle switch (19).
(6) Install wire no. 6 (18) on high idle switch (19) with screw (17).
(9) Remove three nuts (6) from CB no. 1 (9), no. 6 (11) and no. 9 (13).
(10) Install wire no. 1 (12) on CB no. 9 (13), wire no. 4 (10) on CB no. 6 (11) and wire no. 2 (8) on CB no. 1
(9) with three new lockwashers (7) and nuts (6).
10
6
7
12
6
7
11
14
15
6
16
7
8
9
13
4--579
4 589
Change 1
