TM 5-5420-234-14&P
This task covers:
a.
Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic's:
BAP control valve removed (para 4-44)
Automotive (SC 5180-90-N26)
BAP front pin lock guard plate removed (para 4-35)
Materials/Parts
Lockwasher (25) (Item 29, Appendix K)
WARNING
Air system is under pressure. Take care not to direct air flow toward personnel or
injury to personnel could occur.
a. Removal.
(1) Remove nut (1), lockwasher (2), and loop clamp (3) from tubing (4). Remove tubing (4) from BAP
frame. Discard lockwasher.
(2) Loosen tube nuts (5 and 6) on each end of tubing (4), and disconnect tubing (4) from two elbows (7 and
8).
NOTE
Steps 3 through 11 apply to curb-side air lines. Go to Step 12 for road-side
air lines.
(3) Remove elbow (7) from pipe coupling (9).
(4) Loosen tube nut (10) on each end of tubing (11), and disconnect tubing (11) from adapter (12) and tube
nipple (13). Remove adapter (12) from pipe coupling (9).
(5) Remove six nuts (14), lockwashers (15), and loop clamps (16) from tubing (11). Remove tubing (11)
from BAP frame. Discard lockwashers.
(6) Remove adapter (12) and pipe coupling (9) from BAP frame.
(7) Loosen tube nut (17) on each end of tubing (18), and disconnect tubing (18) from tube nipple (13) and
adapter (19).
(8) Remove six nuts (20), lockwashers (21), and loop clamps (22) from tubing (18). Remove tubing (18)
from BAP frame. Discard lockwashers.
