TM 9-2320-279-34-2
Steering System Maintenance Instructions (Cont)
12-7.1. STEERING PUMP REMOVAL/REPAIR/INSTALLATION (M984E1) (CONT).
d. Assembly.
(1)
(2)
Install bearing (1) and retaining ring (2) on shaft (3).
Install seal (4) in body (5).
(3)
(4)
Install spacer (6) and shaft (3) in body (5).
Install retaining ring (7) in body (5).
NOTE
There are two models of pumps.
Model A uses a coil spring, a pressure
plate with 0.0595 in. (1.5 mm)
diameter holes and body with
extended hub. Model B uses a wave
spring, pressure plate with 0.312 in.
(8 mm) diameter holes and body with
a short hub. Procedures are the same.
Refer to TM 9-2320-279-24P when
ordering parts.
(5)
(6)
(7)
Install pressure plate (10) in body (5).
For Model A install spring with large
end toward body.
Install spring (8) in body (5).
Install preformed packing (9) on pressure
plate (10).
12-48.4
Change 2
