TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
(87) If tooth contact is like pattern E, move pinion away
from ring gear (13) by adding shims. Repeat steps (72)
through (83).
(88) Tighten four screws (41 and 44) to
370 to 430 lb-ft (502 to 583 ).
NOTE
Bearing adjuster may be turned slightly
to aline adjuster locks.
(89) Install adjuster lock (49) and cotter
pin (50) on bearing cap (43).
(90) Install lockwire on four screws (41
and 44).
(91)
(92)
Install adjuster lock (51) with two
screws (52).
Install lockwire on two screws (52).
9-79
