TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance instructions (Cont)
9-7. DIFFERENTIAL CARRIER, AXLE NO. 1 REMOVAL/INSTALLATION (CONT).
a. Removal.
NOTE
.
There are two models of axle housings: Model A and Model B. The differential carrier
is mounted on Model A housing by studs, lockwashers, and nuts. The differential
carrier is mounted on Model B housing by a combination of studs, lockwashers, and
nuts, and screws and lockwashers.
.
Do steps (1), (2), and (3) through (5) for Model A housing.
.
Do steps (1) and (2.1) through (5) for Model B housing.
(1)
Mark location of air line brackets (1) on differential carrier (2).
(2)
Remove 12 nuts (3), lockwashers (4), and three air line brackets (1) from differential carrier (2).
(2.1) Remove four nuts (3) and lockwashers (4) from differential carrier (2).
(2.2) Tag and mark placement of 2 1/4 inch screws and 1 3/4 inch screws during removal.
(2.3) Remove eight screws (4.1), lockwashers (4.2), and three air line brackets (1).
WARNING
Keep out from under differential carrier. Serious injury may result if differential
carrier falls from lifting device.
CAUTION
Do not strike differential carrier to loosen if stuck. Tap around edge of flange to
avoid damage.
(3)
Attach lifting device to differential carrier (2).
(4)
Soldier A removes differential carrier (2) while Soldier B operates lifting device.
(5)
Mount differential carrier (2) on stand. Remove lifting device.
9-20 Change 3
