TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-19. SECOND CLUTCH AND CENTER SUPPORT HOUSING REMOVAL/REPAIR/
INSTALLATION (CONT).
(3)
Cut and remove four retaining rings (5).
(4)
Remove clutch ring (6) from second
clutch piston (1).
(5)
Remove 20 springs (7) from second
clutch piston (1).
c.
Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in
well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
(1)
Clean all metallic parts with drycleaning solvent and inspect for damage. Replace damaged
parts.
(2)
Replace piston release springs if any three in each set of 20 do not meet the following
load-height requirements:
(a)
Length without load must be at least 1.29 in. (32.8 mm).
(b)
Length under load must be at least 0.82 in. (20.8 mm) with load of 4.3 to 5.7 lb-ft (19.1 to
25.4N).
d.
Assembly.
(1)
Set second clutch piston (1) in rear
cavity of center support housing (2).
(2)
Install 20 piston release springs (3) in
second clutch piston (1).
(3)
Install clutch ring (4) on second clutch
piston (1).
CAUTION
Clutch ring must be pushed completely
down in center support housing while
installing retaining rings or clutch
clearance will be wrong.
(4)
Install four retaining rings (5). Remove
second clutch piston (1) from center
support housing (2).
7-132
Change 3
