T M 9 - 2 3 2 0 - 2 7 9 - 3 4 - 1
Transmission Maintenance Instructions (Cont)
7-18. THIRD CLUTCH AND CENTER SUPPORT HOUSING REMOVAL/INSTALLATION
(CONT).
(11) Soak four friction
plates (13) in oil for
2 minutes.
N O T E
Thick steel plates must be
installed on bottom of stack.
(12) Install steel plate (14) with
gap (15) facing as shown.
(13) Install seven clutch
plates (13 and 14), starting
with friction plate (13) and
alternating with steel
plate (14).
(14) Install backplate (16).
(15) Install retaining ring (17)
with gap opposite oil pan
side (12) of transmission
housing (4).
f .
Follow-on Maintenance. Install fourth clutch assembly (para 7-17).
END OF TASK
7-19. SECOND CLUTCH AND CENTER SUPPORT HOUSING REMOVAL/REPAIR/
INSTALLATION.
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
INITIAL SETUP
d. Assembly
e. Installation
f. Follow-on Maintenance
Models
All
Test Equipment
None
Special Tools
None
Supplies
Oil, lubricating, Item 46, Appendix C
Solvent, dry cleaning, Item 57, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer
References
None
Equipment Condition
TM or Para
Condition Description
Para 7-18
Third clutch and center
support housing removed.
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
General Support
7-130
