TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
d . A s s e m b l y .
(1)
Install bearing (1) in ground sleeve
bore (2) using bearing installer.
(2)
Set torque converter housing (3) on
wooden blocks.
(3)
Install gasket (4) on torque converter
housing (3).
(4)
Aline holes and install front support
assembly (5).
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Install three screws (6) across front
support assembly (5).
Install 15 screws (7) around outer edge
of front support assembly (5).
Install screw (8).
Tighten three screws (6), 15 screws (7),
and screw (8) to 36 to 43 lb-ft (49 to
58 Nm).
Install main pressure regulator
valve (9) small end first.
Install main pressure regulator valve
spring (10) and valve stop (11).
Install retainer washer (12) on main
pressure regulator valve spring (10).
Soldier A installs retaining ring (13)
while Soldier B pushes retainer
washer (12).
Change 3
7-61