TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
(8) Install spacer (7) over ground sleeve (5) on pump (3).
(9) Install retaining ring (8) on ground sleeve (5).
(10) Coat pump hub (3) and hub area (9) with lubricating
oil.
f .
follow-on Maintenance. Install torque converter stator into torque converter housing (para 7-7).
END OF TASK
7-9. TORQUE CONVERTER HOUSING REMOVAL/REPAlR/lNSTALLATION.
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d. Assembly
e. Installation
f. Follow-on Maintenance
INITIAL SETUP
Models
All
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
Test Equipment
References
None
None
Special Tools
Equipment Condition
Pitot tube guide screws (2) J6889-1
Front support needle bearing installer J24197
TM or Para
Para 7-8
Condition Description
Torque converter pump
Fabricated Tools
removed from torque
Lifting eyes, Item 1, Appendix B
converter housing.
Supplies
Special Environmental Conditions
Oil, lubricating, Item 46, Appendix C
None
Adhesive-sealant, silicone, Item 6, Appendix C
Solvent, dry cleaning, Item 57, Appendix C
General Safety Instructions
Tags, identification, Item 60, Appendix C
None
Level of Maintenance
General Support
7-55
