TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-7. TORQUE CONVERTER STATOR REMOVAL/REPAIR/INSTALLATION.
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning/Inspection
f. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Special TOOls
Stator roller holder J24218-2
Supplies
Oil, lubricating, Item 46, Appendix C
Solvent, drycleaning, Item 57, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer
References
None
Equipment Conditions
TM or Para
Condition Description
Para 7-5
Transmission
installed
on transmission stand.
Para 7-6
Flywheel assembly
removed.
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
General Support
NOTE
Twist stator counterclockwise and
away from torque converter pump
when removing stator from shaft.
Bearings and springs may fall out
when stator is removed.
a.
Removal. Remove stator (1) from shaft (2).
b. Disassembly.
(1)
Hold rim of stator (1) on work surface.
(2)
Turning roller race (2) clockwise, slowly
remove roller race from stator (1).
(3)
Remove roller bearing (3) and thrust
bearing race (4) from stator (1).
NOTE
Note orientation of springs prior to removal
from stator.
(4)
Remove 10 rollers (5) and 10 roller
springs (6) from stator (1).
Change 3
7-47
