TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-6. FLYWHEEL ASSEMBLY REMOVAL/REPAIR/INSTALLATION (CONT).
(7)
Install one screw (8) and washer (9)
through hole (10) in flywheel (7).
Tighten screw until snug.
(8)
Remove lifting device from lifting
bracket.
NOTE
Lifting bracket is used to turn flywheel for
access to screw holes inside converter
housing.
(9)
Install 29 screws (8) and washers (9)
through holes (10) in flywheel (7).
Tighten screws until snug.
(10)
Tighten 30 screws (8) to 41 to 49 lb-ft (56 to 66 Nm).
(11)
Remove two screws (1) and washers (2).
(12) Remove lifting bracket.
(13)
Install gasket (11) and access cover (12).
(14)
Install two screws (13).
(15)
Tighten two screws (13) to 26 to 32 lb-ft (35 to 43 Nm).
f.
Follow-on Maintenance. Remove transmission from transmission stand (para 7-5).
END OF TASK
7-46
Change 3