TM 9-2320-279-34-1
6-96
Change 5
Electrical System Maintenance Instructions (Cont)
6-14. ENGINE WIRING HARNESS REMOVAL/INSTALLATION (CONT).
b. Installation.
(1)
Wrap electrical tape around loose wires of harness (1) to make it easier to thread wires through
engine.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
NOTE
Apply electrical sealant to exposed wire connectors after installing connectors.
(2)
Install two connectors (2) to receptacles (3).
(3)
Connect two-pin connector (4).
(4)
Begin threading taped ends of harness (1) through vehicle from beneath right rear corner of
engine.
