TM 9-2320-279-20-2
a.
Winches, Cranes, and Power Takeoff (PTO) Maintenance Instructions (Cont)
Disassembly.
NOTE
Both connectors are disassembled the same way.
(1) Remove two screws (1), lockwashers (2), ground wire (3), and two clamps (4) from cable (5).
(2) Remove socket (6) and ring (7) from connector (8).
(3) Slide socket (6) and ring (7) down cable (5).
NOTE
Note position of wires in grommet.
(4) Remove five wires (9) from connector (8).
(5) Remove preformed packing (10), grommet (11), and sleeve (12) from connector (8).
(6) Remove five pins (13) from wires (9).
(7) Remove ring (7) and socket (6) from cable (5).
b. Assembly.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Install socket (6), ring (7), and sleeve (12) on cable (5).
Install five pins (13) on wires (9).
Install grommet (11) in connector (8).
Install five wires (9) in grommet (11).
Install connector (8) on sleeve (12).
Install preformed packing (10) on connector (8).
Install ring (7) and socket (6) on connector (8) with two clamps (4), ground wire (3), two
screws (1) and lockwashers (2).
Check continuity between pins on both ends of remote control cable. If no continuity between
same wires, repair cable.
c. Follow-on Maintenance. Stow remote control cable (TM 9-2320-279-10).
END OF TASK
17-126
