TM 9-2320-279-20-2
Cab and Body Maintenance Instructions (Cont)
16-32.1 THREE-POINT SEATBELT REMOVAL/INSTALLATION (MODEL A) (CONT).
1
C.
Installation.
(1)
(2)
(3)
(4)
16-130.4
Install retractor (1) with screw (2),
washer (3), and locknut (4) to cab (5).
NOTE
Make sure belt is not twisted and is
centered in windshield washer
bracket. Belt must move freely
between bracket and installed
windshield washer reservoir.
Comfort latch must be mounted
vertically in line with belt, hang
directly below D-loop mounting, and
remain rigid after tightening.
D-loop and plastic washers must
move freely after screw is tightened
and when belt is removed and
retracted.
Install D-loop (6) with screw (7), two
washers (8), washer (9), and locknut (10) to
cab (5). Tighten to 70 to 75 lb-in (8 Nm).
NOTE
Belt end and tether must be just free
to rotate after nut is tightened.
Tether must be positioned 45°
rearward and downward.
Install belt end (11) and tether (12) on
seat (13) with screw (14), washer (15),
and locknut (16). Tighten to 40 lb-ft (54
N°m).
Install other end of tether (121 with
washer (17) and screw (18) to cab (5).
Change 2
