TM 9-2320-279-20-2
16-130
Change 5
Cab and Body Maintenance Instructions (Cont)
Supplies
Solvent, drycleaning, Item 47, Appendix C
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-10 Shut off engine.
16-32. SEATBELT REMOVAL/INSTALLATION (WITHOUT SHOULDER HARNESS).
Models
All
General Safety Instructions
None
Test Equipment
None
INITIAL SETUP
Special Tools
None
Personnel Required
MOS 63S, Heavy wheel vehicle mechanic
References
None
Special Environmental Conditions
None
a. Removal.
(1)
Move seat (1) forward all the way.
(2)
Remove nut (2) and screw (3) from
each side of seat (1).
(3)
Remove screws (4) and washers (5)
from anchor straps (6). Remove
seatbelts (7).
b. Cleaning/Inspection.
WARNING
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. Keep away from heat or flame. Never smoke
when using drycleaning solvent; the flashpoint for Type II is 140_F (60_C) and for
Type III it is 200_F (93_C). Failure to comply may result in injury or death to
personnel.
If personnel become dizzy while using drycleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean metal surfaces with dry cleaning solvent.
(2)
Check for cracked surfaces or broken parts and frayed or torn webbing.
(3)
Replace all damaged parts.
c. Installation.
(1)
Install seatbelt (7) and anchor strap (6) to cab with washer (5) and screw (4).
(2)
Install anchor strap (6) and seatbelt (7) to seat (1) with screw (3) and nut (2).
(3)
Pull loose end of anchor strap (6) to remove slack from anchor strap.
d. Follow-on Maintenance. None
END OF TASK
